深圳市中新永盛科技有限公司

Remote control test stand manual

Function key

SW1：Set key

Shift key

SW2: up key

SW3: down key

SW4: left shift key

SW5: right shift key

1 first press (SW1), then press (SW3), after 3 seconds into the set state, LED3 display

Show "01", and flicker, [at this time if press again (SW1) system will exit set state]

When the remote signal is received, the decimal on the right of LED3 is lit. Use the shift key to move the LED

When the first shift button is applied, the decimal point on the right of the LED3 is moved to the LED lamp.

The first row on the first, indicating that the signal has been removed, waiting for positioning

(SW1) preservation. At this time:

1).LED3 display plus 1, and stop flashing, waiting for the next remote signal, [press

The (SW1) system will exit the setting state] when the remote signal is received, the LED3 flashes

And the right decimal lit.

2) with displacement keys to locate, with (SW1) save.

3) repeat. 1)-2)operation until the number of keys set is 64, the system will automatically withdraw from the settings like

3) State.

2 in the usual state, (SW4) (SW5) can adjust the required set key position (1-64), adjust

After the whole good enters the set state, the key or the section key can be directly set without affecting.

The position before setting.

3 first press (SW2) and then press (SW3) after 3 seconds, LED3+LED lamp display serial number, press

Key release back to normal state.

Size：180cm*130cm*110cm

Weight： 0.75kg

功能键 SW1:设置键 位移键 SW2:上移键 SW3:下移键 SW4:左移键 SW5:右移键 1.先按下（SW1）,再按下（SW3）,3秒后进入设置状态,LED3显   示"01",并且闪烁,[此时若再次按下（SW1）系统会退出设置状态]   当接收到遥控器信号后,LED3右边的小数点亮.用位移键来移动LED   灯的位置,当次按位移键时,LED3右边的小数点被移到LED灯的   排个上,表示信号已经取出,等待着定位,选定位置后用  （SW1）保存。此时: 1).LED3显示加1,并停止闪烁，在等待下一个遥控器信号,[此时若按   下（SW1）系统会退出设置状态]当接收到遥控器信号后,LED3闪烁   并右边的小数点亮。  2).用位移键来定位,用（SW1）保存.

3).重复1)-2)操作,直到所设置的键数为64,系统会自动退出设置状

  态.

2.在通常状态下,(SW4）（SW5）可调整所需设置键的位置(1-64),调

 整好进入设置状态后,可直接对该键或该段键进行设置,而不影响

 该位置之前的设置.

3.先按下（SW2）再按下（SW3）3秒后，LED3+LED灯显示序列号，按

 键放开回到通常状态。